[EU/US Direct] TRONXY® X5SA-2E CoreXY 3D Printer Kit with Dual Titan Extruder, Dual Z-Axis, and 330*330*400mm Printing Size. TMC2225 Ultra Quiet. Supports Dual Colors,
How to Use the TRONXY X5SA-2E Dual Colors 3D Printer
Table of Contents
- Getting Started
- Assembling the Printer
- Loading Filament
- Calibrating the Printer
- Printing a Model
Getting Started
Before using the TRONXY X5SA-2E Dual Colors 3D Printer, make sure you have the following:
- TRONXY X5SA-2E Dual Colors 3D Printer Kit
- Power supply
- Filament spools
- USB cable
- SD card
- Computer or mobile device
Assembling the Printer
Follow these steps to assemble the printer:
- Unbox all the components.
- Refer to the assembly manual to identify each part.
- Attach the frame and secure it using the provided screws.
- Install the Z-axis motors and connect the cables correctly.
- Attach the Titan extruders and secure them in place.
- Mount the printing platform correctly.
- Connect all the necessary cables and ensure they are properly connected.
- Attach the filament spools to the designated holders.
- Plug in the power supply.
Loading Filament
Follow these steps to load filament into the printer:
- Power on the printer.
- Go to the control panel and choose the “Filament” option.
- Select “Load Filament” and wait for the extruders to heat up.
- Insert the end of the filament into the extruder, pushing it through until it reaches the nozzle.
- Allow the printer to feed the filament until it comes out of the nozzle smoothly.
- Repeat the process for each extruder if using dual colors.
Calibrating the Printer
Follow these steps to calibrate the printer:
- Go to the control panel and select the “Calibration” option.
- Choose “Auto Bed Leveling” and wait for the process to complete.
- Manually adjust the bed leveling if necessary using the provided screws.
- Perform a test print to check the calibration.
Printing a Model
Follow these steps to print a model:
- Prepare the model file either by downloading or creating it.
- Save the model file onto the SD card or connect the printer to your computer via USB.
- Insert the SD card into the printer or establish a connection between the printer and your computer.
- Go to the control panel and choose the “Print” option.
- Select the model file and adjust any printing settings if needed.
- Start the print process and monitor the progress.
, , TRONXY
Reviews
Clear filtersThere are no reviews yet.