URUAV 3D Printed TPU Canopy for Moubla6 / Mobula7 RC Drone FPV Racing, Compatible with Runcam Nano 3 and Caddx Ant Lite FPV Cameras

URUAV 3D Printed TPU Canopy for Moubla6 / Mobula7 RC Drone FPV Racing, Compatible with Runcam Nano 3 and Caddx Ant Lite FPV Cameras,

How to Use URUAV 3D Printing TPU Canopy

Introduction

This guide will walk you through the steps to use the URUAV 3D Printing TPU Canopy. This canopy is compatible with the Runcam Nano 3 and Caddx Ant Lite FPV cameras, and is designed for use with the Mobula6 and Mobula7 FPV racing drones. Follow the instructions below to install and use the canopy effectively.

Installation

1. Start by removing the existing canopy from your RC drone.
2. Take the URUAV 3D Printing TPU Canopy out of the package.
3. Align the mounting holes on the canopy with the holes on your drone frame, making sure it fits snugly.
4. Push the canopy onto the frame until it locks into place.

Camera Compatibility

The URUAV 3D Printing TPU Canopy is designed to be compatible with the Runcam Nano 3 and Caddx Ant Lite FPV cameras. Ensure that you have one of these cameras before proceeding.

Usage

1. Mount the Runcam Nano 3 or Caddx Ant Lite FPV camera onto the designated mount inside the canopy.
2. Secure the camera in place using the provided screws.
3. Connect the camera’s video cable to the video transmitter on your drone.
4. Power on your drone and camera to confirm proper functioning.
5. Adjust the camera angle if needed for the desired view during FPV flight.

Note: Please refer to the user manuals of your specific camera and drone for more detailed instructions on camera and drone setup.

Conclusion

By following these steps, you should be able to successfully install and use the URUAV 3D Printing TPU Canopy with your Runcam Nano 3 or Caddx Ant Lite FPV camera on your Mobula6 or Mobula7 RC drone. Enjoy FPV racing with added protection for your camera!

, ,